![]() ![]() In the example below i’ve added vMotion as a system vlan for demo purposes but you would not normally add vMotion as a system vlan in a production network.Ĥ. Along with defining system vlans here they must also be defined on the vethernet port-profile like in step 4. Because system vlans are always in a forwarding state they actually by pass any QOS or access-lists. These types of vlans should include management/service console, nexus control, nexus packet and iSCSI. ![]() System vlans are priority vlans which always remain in a forwarding state. Type in the commands as you see them below including any vlans that you want included in the trunk. The other type we can create is vethernet which is for virtual machine networks. If you are going to be connecting multiple ESX or ESXi hosts to the Nexus switch you must create separate ethernet port-profiles for each, especially if you are using etherchannel. This port profile is of type ethernet which means that it is assigned to physical interfaces of your ESX host. The first thing we need to do is configure our vlans.ģ. ![]() Here you can see that the Virtual Supervisor Module is active and that the ip address is 192.168.1.80.Ģ. Let’s log into the Nexus 1000v console and type show module. This is part 3 of the Cisco Nexus 1000v installation tutorials.ġ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |